Painting over damp is the decorating job that always comes back to haunt you. The brown tide mark on the chimney breast or the grey bloom above the skirting disappears under two coats of emulsion, and then returns within a month, often larger. This explainer covers why that happens, how to find the source in a typical Croydon house, when a stain blocking primer is all you need, which breathable paints suit older walls, and what a painter and decorator typically charges to put it right.

Why painting over damp always fails

Paint is a skin, and on a dry wall it bonds to the plaster and stays put for years. On a wall that is still taking in water, the moisture pushes outwards through the plaster, lifts the new paint from behind and carries dissolved salts with it. Those salts dry on the surface as a white crust and the paint flakes off around them. No coating holds back water arriving from the other side of the wall, which is why painting over damp fails every time.

The distinction that matters is between a stain and active damp. A stain is the mark left by a leak that has since been fixed: a dry, brown ring with no smell and a moisture meter reading no higher than the wall around it. Active damp is cold to the touch, often darker at the edges, and may carry a musty smell or black mould spots. The first can be painted over with the right primer; the second cannot be painted at all until the source is dealt with.

Finding the source before you buy paint

Work through the likely causes in order, because the cheapest are also the most common. Most damp in Croydon homes is not rising damp; it is water getting in from above or condensation forming inside.

  1. Look outside first. Blocked or leaking gutters, a cracked downpipe and failed pointing above the stain account for most patches high on an external wall.
  2. Check the roof and any flashing around the chimney if the stain is on a chimney breast upstairs, and check the chimney itself is capped and ventilated.
  3. Trace plumbing. A stain below a bathroom or beside a radiator pipe is usually a slow leak, not weather.
  4. Consider condensation if the damp is on a cold external wall in a bedroom, behind furniture or in a corner, with mould rather than a tide mark.
  5. Check the ground level outside is at least 150mm below the damp proof course and that paths and flower beds have not been built up against the wall.

Only when all of those are clear is it worth paying for a survey. If you rent, the repair is your landlord’s responsibility under section 11 of the Landlord and Tenant Act 1985, and social landlords now face fixed timescales under Awaab’s Law in the Social Housing Regulation Act 2023. The government’s guidance on damp and mould sets out what landlords are expected to do.

What is different about Croydon houses

Croydon’s housing stock splits roughly by geography. North of the town centre, around Thornton Heath, Norbury and South Norwood, the streets are Victorian terraces on London clay, with solid nine inch walls, slate roofs and chimney breasts that have often been sealed up without a vent. These walls were built to breathe through lime plaster, and they suffer when sealed with modern plastic paints and cement renders. South and east, in Purley, Coulsdon and Sanderstead, the 1930s semis sit on chalk, drain better, and tend to get condensation in cold bay windows rather than penetrating damp.

Postwar flats and town centre conversions have their own pattern: concrete balconies that bridge the damp proofing, and bathrooms with no extractor fan. A gutter blocked in October is usually a stain by January. Our Croydon hub and our Croydon decorating questions cover the other jobs that follow the same calendar.

Stain blockers, breathable paints and the right order

Once the wall is dry, and only then, a stain blocking primer stops an old water mark bleeding through. Ordinary emulsion will not do it, because the tannins and salts in the stain dissolve into water-based paint. Use a shellac or oil-based stain blocker on the mark and 100mm around it, let it dry fully, then paint the whole wall so the patch does not show as a change in texture.

On a solid-walled Victorian house, choose a breathable finish for the top coats: a clay paint, a limewash on bare plaster, or a breathable mineral emulsion, all of which let residual moisture out rather than trapping it. Avoid so-called anti-damp paints on anything other than a small, fully dried patch, since they work by sealing and simply move the problem along the wall. If the plaster sounds hollow when tapped, it has blown and needs hacking off and replastering with a lime or renovating plaster before any paint goes near it. Leave new plaster to dry for at least a week per 5mm of thickness, and do not rush it in winter.

What painting over a damp stain typically costs

If the cause is a gutter, clearing and resealing it typically runs to £80 to £150, and repointing a patch of brickwork is £150 to £400 depending on access. A decorator sealing and repainting a single stained wall usually charges a half day to a day, and typical day rates across Croydon sit at £180 to £280, higher than the national range because of London overheads. Replastering one wall in lime is typically £300 to £600. All of these are indicative ranges, not quotes, and the first visit should always be about the water, not the paint.

When to call a professional

Painting over damp that has been fixed is a job most householders can do, provided the wall has been given weeks, not days, to dry. Call a roofer or plumber for the source, a surveyor if you cannot find it, and a decorator for the finish once a moisture meter confirms the wall is dry. If the plaster is crumbling or the stain covers more than a square metre, have the whole wall assessed before anyone opens a tin.

Our free help desk can find the right trade for each stage. Tell us where the stain is and what you have already checked through our request help page. The team reviews every enquiry and confirms availability and credentials before anything is agreed, so nothing is booked until they come back to you.

Questions people ask

Can you paint over a damp stain once it is dry?

Yes, provided the leak that caused it has been fixed and the wall has dried fully, which can take several weeks in winter. Seal the mark with a shellac or oil-based stain blocking primer first, then repaint the whole wall. Emulsion on its own will not hide a water stain, however many coats you apply.

How do I know if damp is still active?

Press the back of your hand to the patch: active damp feels cold and slightly clammy compared with the wall around it. A moisture meter reading higher than a dry area of the same wall, a musty smell, black mould spots or a white salt crust all point to water still getting in. A dry brown ring with none of those is just a stain.

Is damp proof paint worth using?

Rarely. Damp proof and anti-mould paints work by sealing the surface, which can hold back a small amount of moisture for a while but traps water in the wall and moves the problem elsewhere. They are no substitute for finding the leak. On older solid walls, a breathable clay, lime or mineral paint is the better choice once the wall is dry.

Who pays to fix damp in a rented home in Croydon?

The landlord, in almost every case. Section 11 of the Landlord and Tenant Act 1985 makes them responsible for the structure, exterior, gutters and pipes, and social landlords must now act within set timescales under Awaab's Law. Report it in writing, keep photographs, and contact Croydon Council's private sector housing team if nothing happens.

Ready to take the next step?

Tell the household desk what has happened, where you are and when you need help. We will review it and explain your options.

Describe your job →

Guidance is general and refers to the authority that sets each rule. Costs are indicative ranges; always get written quotes. Trade availability and credentials are confirmed when you enquire.